Need metal roof installation in Belton? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
A metal roof is what Roofing Brothers is known for, and it has been since 2002. On a Belton home that means standing seam or exposed fastener panels set over sound decking and real underlayment, with the ridge, valley and eave trim cut and fit on site rather than forced out of a box.
Our metal roof installation work in Belton is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Belton metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
Four steps and no surprises. This is how we have done it since 2002.
Panel type comes first — standing seam or exposed fastener — then color, then trim. We walk you through the trade offs on each one.
Rotten decking gets replaced and priced with you before it is covered up. Nobody wants to learn about that afterward.
Synthetic underlayment over the whole roof, ice and water shield in the valleys and at the eaves, then panels set square on the correct fastener spacing.
Every penetration gets a proper boot or flashing instead of a bead of sealant and a hope.
The things people want to know before they tell us to go ahead.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Belton homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Much less than people expect. Over solid decking with underlayment, a Belton metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Most Belton metal roof jobs land between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off is involved. Standing seam runs higher than exposed fastener panels. We measure before we quote and the estimate is free.
A straightforward Belton house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Real feedback from homeowners we have worked for.
"They reroofed the porch and matched it to the house so well you cannot tell where the old work stops and the new starts."
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"New gutters and guards after they did our roof. No more climbing up there every October to dig out pine needles by hand."